Compressed Air Piping: Aluminum, Steel, and Black Iron Costs

6 min readApril 27, 2026

Compare the installed and ongoing costs of aluminum, galvanized steel, and black iron piping. Material price is only one part of the total.

Piping affects the cost and performance of the entire air system. Low-cost black iron may save on materials, but corrosion, leaking joints, and repair labor can increase expenses over time. Include those costs when planning a new layout.

The best material depends on installation conditions, expected service life, and local labor costs. These are the main tradeoffs among three common options.

Black iron and steel pipe

Black iron is inexpensive and familiar to many installers. Moisture can corrode its interior, and threaded joints may leak as they age. Changes to the layout require cutting, threading, and resealing connections.

Where black iron can fit

  • Small systems with one straight pipe run.
  • Temporary installations.
  • Installations expected to be replaced within 10 years.

Galvanized steel

Galvanized steel adds a corrosion-resistant zinc coating to steel pipe. It costs more than black iron and uses the same threaded installation method. The coating slows corrosion, but eventual flaking can send particles into filters and tools.

Aluminum pipe systems

Aluminum systems such as Prevost and Transair use push-to-connect fittings to reduce installation labor. The interior resists corrosion, and modular fittings make later changes easier. Materials cost more than black iron, but shorter installation time can offset that difference.

Cost example: 200 feet of 1-inch main line

ItemBlack ironGalvanizedAluminum (Prevost)
Materials cost$1,200$1,800$2,800
Install labor (hours)16–2016–204–6
Install labor cost @ $120/hr$2,160$2,160$600
Total install cost$3,360$3,960$3,400
10-yr leak loss (energy)$2,500$1,400$300
10-yr maintenance / re-pipe$1,500$800$0
10-year total cost of ownership$7,360$6,160$3,700

These estimates reflect typical projects we've worked on. Labor rates, route complexity, and leak maintenance change the actual cost. In this comparison, aluminum's higher material price is offset by lower labor and ongoing costs over 10 years.

Reasons we use Prevost

  • Push-to-connect fittings can reduce installation time by roughly a factor of four.
  • The aluminum interior resists rust and maintains a smooth bore.
  • Modular fittings allow new drops, rerouting, and expansion.
  • Quick-disconnect couplers are available in industrial-standard profiles.
  • Lifetime warranty on materials and joints.

Plan a system for your facility.

Describe your equipment and air demand. We can help with selection, installation, and ongoing service.